more in www.dreamsatellitetv.com.cn
How to setup your homecast receiver?
Step 1: you make sure whether your satellite cable connect with your homecast receiver, put the plug in the interface 'Dish IN'.
Step 2: Press the MENU button to show the main menu, then press 'ok' button and enter sub menu, you select 'installation' -> press '>' right button, select 'Dish setup' button -> press'ok' button, enter the password pop-up window, the default password is '1234', you input it then it will skip into Dish setup window.
Step3: Firstly you check the top of 'dish setup' window, it will show signal strength and signal quality, as usual you can find signal precent in the left, it is more than 45%, but it will show 0% in the right, if it is 0% or less than 40% in the right, you can't watch tv programs, so you need to find back your lost tv channels from here by checking satellite signal and setup satellite parameters.
Step 4: Setup 'LNB type' into '11300' (default is 9750/10750), you needn't modify other parameters in 'dish setup' window, then check whether signal come back, (it won't show 0% in the right), if it shows 0% yet, you will do the next step.
Step 5: press 'exit' button and enter 'factory reset', then 'ok' button, select 'yes', all will come to the factory setup, then you do it according to the second step again.
Step 6: enter 'dish setup' window, then setup 'LNB type' into 11300, then skip into Goto 'Auto search', press it, you will get back your lost tv channels. |
just is this problem, now it is ok. thank you very much.
